Rack-mountable LCD

Dimension Systems Inc. (DTI; Rochester, NY; www.dti3d.com), a manufacturer of 3-D flat-panel shows and producer of commercially obtainable 2-D/three-D switchable flat-panel shows, has designed its 18.one-in. three-D LCD offered in a number of rack-mount versions. Arnold Lagergren, president of DTI, mentioned that “these new solutions and three-D part kits are made for use in programs for instance armed forces and security marketplaces, arcade video games, and R&D. I am happy that we are able to give these 2-D/three-D switchable flat panels in configurations that enable mounting in a regular 19-in. rack.”The brand new rack-mountable products and solutions are available in two variations. The 3-D components kits contain the 2-D/3-D flat panel, circuit boards, cabling, and Manage panels and therefore are specific at makers who will be by now skilled in rack-mounting products and wish to incorporate DTI 3-D engineering into their own personal solutions.The rack-mount Edition from the Display screen features all components noted higher than furthermore the body and hardware needed for mounting the Exhibit in a standard 19-in. industrial rack. Drawer slide variations are also available to supply less complicated access to rear panel I/O and power connections.

Installing to the Rack

This portion provides Directions for installing the Liquid crystal rackmountsales display console tray inside of a four-submit rack cupboard. Thepullout tray assembly features a keyboard with touchpad as well as a flat-panel observe that rotates up fromthe console tray for use. An attached cable-management arm routes the observe, electrical power, USB and
keyboard/touchpad cables for the back again on the rack. The watch’s power source is set up within the console
tray.The Liquid crystal display console tray is set up utilizing the Dell ReadyRails™ II slide rails in any procedure company’srack cabinet.For removal Guidelines, see Removal in the Rack on page 19.NOTE: 1U of free rack Room is required to mount the console tray.Right before putting in both Instrument-a lot less or tooled rails, you must eliminate the delivery pins with the slide rail
brackets.

To install Resource-much less rails:

Situation the left and suitable rail mounts labeled FRONT, then orient and seat each mount during the
holes around the entrance facet in the vertical rack flanges. Align Each and every mount in the bottom and major holes of the desired U spaces right until the latch clicks intoplace.Engage the again conclude of your rail right until it entirely seats while in the vertical rack flange as well as the latch clicksinto area.Eliminate the screw through the front mounting bracket employing a Torx™ screwdriver, then removethe pins from your entrance and rear mounting brackets utilizing a flat-tipped screwdriver.Pull and rotate the rail latch sub-assemblies to remove them from your mounting brackets.

 Preparing to Install Tooled Rails

To set up tooled rails: . Attach the remaining and ideal mounting rails towards the entrance vertical rack flanges applying two equippedpairs of screws. Slide the still left and suitable back again brackets ahead versus the rear vertical rack flanges and fastenthem using two equipped pairs of screws.To setup the console tray: NOTE: Make sure the process is properly supported untilthe internal rails are inserted into your slide rails onboth sides. Take out any tape securing the check for the keyboard tray previous to inserting it to therack. Affirm the ball-bearing races are in their ahead-most posture. Align and insert the finishes in the interior rails into your finishes of the outer rails. Force the process inward until finally the internal rails are completely inserted.Pull and force the console tray out and in on the rack until it slides easily inside the rack.

Please Post Your Comments & Reviews

Your email address will not be published. Required fields are marked *